Zinco Protection Mat ISM 50, roll 2x25 m, Weight approximately / approx. 850 g/m²
Mechanically heavy-duty / extremely high loadable synthetic fiber mat for use as a protective layer under intensive green roofs, walkways and driveways etc.
grey mottled, made of polyester/polypropylene, strength factor 5, compatible with bitumen, rot-proof, underside impregnated with acrylate binder, water storage capacity approx. 4 l/m², Thickness approx. 6 mm, as a component of a system structure with environmental product declaration EPD and CE marking via ETA no. 13/0668 "Kit for Green Roofs".
| Order Nr.: | 2050 |
|---|---|
| Colour: | grey mottled |
| Length [m]: | 25,0 |
| Material: | Polyester+polypropylene |
| Width [m]: | 2,0 |
| Thickness [mm]: | 6,0 |
| Packaging unit: | Role |
| Weight [g/m²]: | 850,0 |
| CBR test / penetration force [N]: | > 3500 |
| Geotextile strength class / strength factor: | 5 |
| Protection efficiency according to EN ISO 13428 [%]: | Residual thickness ≥ 40 |
| Water storage capacity [l/m²]: | 4,0 |
| Compatible with bitumen: | Yes |
| Non-rotting: | Yes |
| UV-stabilized / protected against UV light: | no |
| Additional info: | underside impregnated with acrylate binder; subsonic noise reduction / insulating subsonic noise VM: +25 dB with gravel / grit and concrete slabs |
made of polyester/polypropylene with needled-in carrier membrane and proven protective effect according to EN ISO 13428, strength class 5, compatible with bitumen, rot-proof, subsonic noise reduction / insulating subsonic noise, underside impregnated with acrylate binder, Weight approx. 850 g/m², Thickness approx. 6 mm, water storage capacity approx. 4 l/m², as a component of a system structure with Environmental Product Declaration EPD and CE marking via ETA No. 13/0668 "Kit for Green Roofs", deliver and install as a mechanical protective layer with 10 cm joint overlap over the entire surface.
Product: Zinco Protection Mat "ISM 50"
Unit: m²
Order Nr.: 2050
These Installation Instructions describe the essential steps for using this product. Please also observe the relevant standards and guidelines, in particular the occupational health and safety regulations.
Installation should not be carried out if there is a risk of storms.
1
Installation:
Protection Mat ISM 50 is laid loose with approximately / approx. 10 cm overlapping. At the edges of roof / perimeter and rising structural elements, it is laid at least up to the upper edge of the covering. Here it can be fixed in place in the meantime with double-sided adhesive tape.
To protect against UV radiation and blowing away, the protective mat must be covered immediately after installation. Short-term protection against wind can also be provided by moistening the mats.
2
Cutting:
We recommend cutting the protective mat with sturdy universal scissors. When cutting, make sure that the waterproofing of the roof is not damaged under any circumstances! If damage does occur, it must be reported and repaired immediately.
The protective mat must be cut out in a circle over roof outlets, approximately / approx. 1 cm larger than the roof outlet all round (cross cutting is not sufficient!).