Zinco Protection Mat / Moisture Retention SSM 45 2 x 10 m, Weight approximately / approx. 470 g/sqm²

Water- and nutrient retaining synthetic fiber mat for use as a protective layer under Green Roofs, gravel layers, concrete slabs, etc.

Order Nr.: 2046
Product information "Zinco Protection Mat / Moisture Retention SSM 45 2 x 10 m, Weight approximately / approx. 470 g/sqm²"

gray, made of recycled polypropylene, strength factor 3, compatible with bitumen, rot-proof, water storage capacity approx. 5 l/sqm Thickness approx. 5 mm, as a component of a system structure with Environmental Product Declaration EPD and CE marking via ETA No. 13/0668 "Kit for Green Roofs".

Order Nr.: 2046
Colour: brown mottled
Length [m]: 10,0
Material: Polyester+polypropylene
Width [m]: 2,0
Thickness [mm]: 5,0
Packaging unit: Role
Weight [g/m²]: 470,0
CBR test / penetration force [N]: > 2000
Geotextile strength class / strength factor: 3
Strip tensile test [%]: > 75
Tensile strength [kN/m]: longitudinal >5.5
Protection efficiency according to EN ISO 13428 [%]: Residual thickness ≥ 25
Water storage capacity [l/m²]: 5,0
Compatible with bitumen: Yes
Non-rotting: Yes
UV-stabilized / protected against UV light: no
Installation Instructions

These Installation Instructions describe the essential steps for using this product. Please also observe the relevant standards and guidelines, in particular the occupational health and safety regulations.

Installation should not be carried out if there is a risk of storms.

1

Installation:

Protection Mat / Moisture Retention SSM 45 is laid loosely above the Root Barrier WSF 40 or on the roof already waterproofed with root resistant waterproofing with approx. 10 cm overlapping. At the edges of roof / perimeter and rising structural elements, it is laid at least up to the top edge of the covering.

To protect against UV radiation and blowing away, the protective mat must be covered immediately after installation. Short-term protection against wind can also be provided by moistening the mats.

2

Cutting:

We recommend cutting the protective mat with sturdy universal scissors. When cutting, make sure that the waterproofing of the roof is not damaged under any circumstances! If damage does occur, it must be reported and repaired immediately.

The protective mat must be cut in a circle over roof outlets, approximately / approx. 1 cm larger than the roof outlet all round (cross cutting is not sufficient!).

This product is also available in other dimensions / measurements / specifications

Zinco Speicherschutzmatte SSM 45, Rolle 2x50 m, Flächenmasse ca. 470 g/m²

Water- and nutrient retaining synthetic fiber mat for use as a protective layer under Green Roofs, gravel layers, concrete slabs, etc.

Zinco Protection Mat / Moisture Retention SSM 45, roll 2x50 m, Weight approximately / approx. 470 g/m²
Water- and nutrient retaining synthetic fiber mat for use as a protective layer under Green Roofs, gravel layers, concrete slabs, etc.
Water- and nutrient retaining synthetic fiber mat for use as a protective layer under Green Roofs, gravel layers, concrete slabs, etc.