Zinco Solar Base Frame SGR 15 Length 950 mm, heights 350/610 mm
One-piece, structurally tested aluminum base frame designed for use on Green Roofs; matched to the ZinCo Solar Base® SB 200.
made of aluminium, mounting surface inclined by 15°, pre-drilled ready for installation, Colour natural aluminium, weight approx. 1.7 kg/piece
| Order Nr.: | 970015 |
|---|---|
| Colour: | Natural aluminum |
| Material: | Aluminum material AlMg3 |
| Length [mm]: | 950 |
| Packaging unit: | Piece |
| Weight [kg]: | 1,7 |
| Additional info: | Front height: approx. 350 mm; Rear height: approx. 610 mm; Inclination of mounting surface: approx. 15°. |
supply structurally tested aluminum frame support for mounting a photovoltaic/solar system and screw fixing to the Zinco Solar Base SB 200. Length approx. 950 mm, height approx. 350 or 610 mm, inclination 15°, pre-drilled for fastening the SMP solar mounting profile.
For the East-West system, two SGR 15 are screw-fixed to the Zinco Solar Base® SB 200-4 for East-West system using the appropriate screw set.
Make: Zinco Solar base frame "SGR 15"
Notice: After mounting the Solar base frames, the wind bracing and the solar mounting profile must be mounted immediately!
Unit: pcs
Order Nr.: 970015
ZinCo Solar Base SB 200 with Solar base frame SGR and wind bracing
Installation SB 200:
Scope of delivery per unit:
- 1 pc. ZinCo Solar Base SB 200
- 2 pcs. hexagonal nuts M10 with flange, A2, DIN 6923, wrench size 15 mm
- 2 pcs. Stainless steel washers
- 1 pc. ZinCo Solar base frame SGR
Installation steps:
Lay out Solar Base SB 200, with pre-assembled fixing points.
Attach the Solar base frame SGR.
Hand-tighten the screws, tightening torque > 20 Nm.
Finished Solar Base SB 200 with Solar base frame SGR.
Notice:
- The material temperature should not be below +5 °C during installation.
- The entire surface of the Solar Base SB 200 must always be covered with bulk material corresponding to the required Superimposed / extra load.
- If the complete PV or thermal system is not installed immediately, the horizontal mounting profiles and wind bracing must be installed in any case.
- Due to the high dead load of thermal systems, wind bracing (WV5) must also be installed at the front.
- Always use a Stainless steel washer Ø inside/outside 10.5/20 mm when mounting horizontal profiles with M8 screws.
- No liability if the installation instructions are not followed.
Installation wind bracing:
Scope of delivery per unit:
1 set of wind bracing consists of:
- 2 pre-drilled aluminium flat strip rods (riveted in the middle)
- 4 pcs. Round head screws M8 × 16, A2, DIN 603
- 4 hexagonal nuts M8, A2, DIN 93
- 5 pcs. Stainless steel washers, Ø inside/outside 10.5/20 mm
Tools required:
- Socket wrench SW 13
Two Solar base frames SGR ...
... with wind bracing
When installing the wind bracing, the positions according to the installation plan must be observed (red crosses). For installation, the wind bracing is pulled apart and screwed to the back of the frame using the four carriage bolts. The carriage bolts are inserted from the inside through the slotted holes (once at the frame high point and once at the frame low point). The screws are tightened to 8 Nm (hand-tight).