Zinco Floraset FS 50 slabs 1 x 1 m, height approximately / approx. 50 mm
Inexpensive drainage element made of expanded polystyrene foam for use with extensive planting on roofs with and without gradients / inclines and on slightly sloping roofs.
Drainage element made of expanded polystyrene (EPS) rigid foam, manufactured without CFCs and without HBCD, with water storage troughs, openings for diffusion and drainage channel system underside, compressive strength at 10% compression approx. 45 kN/sqm, Weight approx. 0.6 kg/sqm.
| Order Nr.: | 3052 |
|---|---|
| Colour: | white |
| Length [m]: | 1,00 |
| Material: | EPS |
| Width [m]: | 1,00 |
| Height [mm]: | 50,00 |
| Packaging unit: | boards |
| Weight [g/m²]: | approximately / approx. 600.00 |
| Pressure [kN/m²]: | 10% = 45 |
| Water storage capacity [l/m²]: | 3 * |
| Water runoff at sheet level at roof slope 1 % [l/(s-m)]: | 0,63 |
| Water runoff at sheet level at 3% gradient / incline [l/(s-m)]: | 0,92 |
| Water discharge at 10% gradient / incline [l/(s-m)]: | 2,11 |
| Compatible with bitumen: | Yes |
| UV-stabilized / protected against UV light: | no |
| Additional info: | Apparent density: approx. 20 kg/m³; filling volume when laying with the studs facing upwards: max. approx. 10 l/m²; * = when laying with the large studs facing downwards |
made of expanded and profiled rigid polystyrene foam, manufactured without CFCs and without HBCD, height approx. 50 mm, with water storage troughs / cells and openings for ventilation and diffusion as well as a multi-directional channel system underside, Weight approx. 0.6 kg/m², pressure load capacity up to approx. 45 kN/m², water drainage capacity tested according to EN ISO 12958: at a gradient of 1 % - approx. 0.63 l/s*m, at a gradient of 2 % - approx. 0.92 l/s*m, with environmental product declaration EPD-ZIC-20200082-CCA1-EN, deliver and install according to manufacturer's instructions.
Product: ZincoFloraset® "FS 50"
Unit: m²
Order Nr.: 3052
These Installation Instructions describe the essential steps for using this product. Please also observe the relevant standards and guidelines, in particular the occupational health and safety regulations.
Installation should not be carried out if there is a risk of storms.
1
Installation:
Floraset® FS 50 slabs are laid butt-jointed, i.e. without overlapping and with the studs facing downwards.*
After installation, the drainage elements must be covered immediately with a Filter Sheet. Both must be covered immediately after installation to protect against UV radiation and blowing away.
2
Cutting:
The Floraset® slabs can be cut with an (electric) foxtail. When cutting, make sure that the already laid layers are not damaged under any circumstances! If damage does occur, it must be reported and repaired immediately.
The drainage elements must be cut out in a circle above roof outlets, approximately / approx. 1 cm larger than the roof outlet all around.
* On flat roofs, the element is laid with the studs facing downwards, for applications on pitched roofs with the studs facing upwards.
This product is also available in other dimensions / measurements / specifications
Inexpensive drainage element made of expanded polystyrene foam for use with extensive planting on roofs with and without gradients / inclines and on slightly sloping roofs.