Zinco Floraset FS 75 slabs 1 x 1 m, height approximately / approx. 75 mm
Drainage element usable on both sides made of expanded polystyrene foam for use with extensive and simple intensive green roofs on shallow and pitched roofs.
stable drainage element made of expanded polystyrene foam (EPS), manufactured without CFCs and without HBCD, with water storage troughs, openings for diffusion and drainage channel system on both sides, compressive strength at 10% compression approx. 55 kN/m², Weight approx. 1.0 kg/sqm.
| Order Nr.: | 3076 |
|---|---|
| Colour: | white |
| Length [m]: | 1,0 |
| Material: | EPS |
| Width [m]: | 1,0 |
| Height [mm]: | 75,0 |
| Packaging unit: | boards |
| Weight [kg/m²]: | 1,0 |
| Pressure [kN/m²]: | 55.0 (with 10% yield) |
| Water storage capacity [l/m²]: | 3,0** |
| Water runoff at sheet level at roof slope 1 % [l/(s-m)]: | 1,54** |
| Water runoff at sheet level at 2% gradient / incline [l/(s-m)]: | 2,21** |
| Compatible with bitumen: | Yes |
| UV-stabilized / protected against UV light: | no |
| Additional info: | Density Apparent density: approx. 23 kg/m³; filling volume when laying with studs facing upwards: approximately / approx. 20 l/m²; * = large studs at the top; ** = large studs at the bottom |
made of expanded polystyrene rigid foam, manufactured without CFCs and without HBCD, height approx. 75 mm, with water storage troughs / cells, openings for ventilation and diffusion as well as multi-directional channel system on both sides, Weight approx. 1 kg/m², pressure load capacity up to approx. 55 kN/m², water drainage capacity tested according to EN ISO 12958: approx. 1.54 l/s*m at a gradient of 1 %, approx. 2.21 l/s*m at a gradient of 2 %, with environmental product declaration EPD-ZIC-20200082-CCA1-EN, deliver and install according to manufacturer's instructions with studs facing downwards.
Product: Zinco Floraset® "FS 75"
Unit: m²
Order Nr.: 3076
These Installation Instructions describe the essential steps for using this product. Please also observe the relevant standards and guidelines, in particular the occupational health and safety regulations.
Installation should not be carried out if there is a risk of storms.
1
Installation:
Floraset® FS 75 slabs are usable on both sides and are laid butt-jointed. They are laid with the studs facing downwards when used on flat roofs and with the studs facing upwards when used on pitched roofs (up to 25° roof slope).
After installation, the drainage elements must be covered immediately (UV protection!) and secured against drifting.
2
Cutting:
The Floraset® slabs can be cut with an (electric) foxtail. When cutting, make sure that the already laid layers are not damaged under any circumstances! If damage does occur, it must be reported and repaired immediately.
Above roof outlets, the drainage elements must be cut out in a circle, approximately / approx. 1 cm larger than the roof outlet.
This product is also available in other dimensions / measurements / specifications
Drainage element usable on both sides made of expanded polystyrene foam for use with extensive and simple intensive green roofs on shallow and pitched roofs.