Zinco Protection Mat TSM 32, roll 2 x 50 m, Weight approximately / approx. 350 g/m²
Inexpensive synthetic fiber mat for use as a separating and protective layer under gravel layers and extensive green roofs.
gray, made of recycled polyester, strength factor 3, compatible with bitumen, rot-proof, water storage capacity approx. 3 l/m², Thickness approx. 3 mm, as a component of a system structure with Environmental Product Declaration EPD and CE marking via ETA No. 13/0668 "Kit for Green Roofs".
| Order Nr.: | 2032 |
|---|---|
| Colour: | gray |
| Length [m]: | 50,0 |
| Material: | Polyester |
| Width [m]: | 2,0 |
| Thickness [mm]: | 3,0 |
| Packaging unit: | Role |
| Weight [g/m²]: | 350,0 |
| CBR test / penetration force [N]: | > 2000 |
| Geotextile strength class / strength factor: | 3 |
| Protection efficiency according to EN ISO 13428 [%]: | Residual thickness ≥ 20 |
| Melting point [°C]: | 260,0 |
| Water storage capacity [l/m²]: | 3,0 |
| Compatible with bitumen: | Yes |
| Non-rotting: | Yes |
| UV-stabilized / protected against UV light: | no |
made of recycled polyester, with tested protective effect
in accordance with EN ISO 13428, grey, strength class 3, compatible with bitumen, rot-proof, Weight approx. 350 g/m², Thickness approx. 3 mm, water storage capacity approx. 3 l/m², as a component of a system structure with Environmental Product Declaration EPD and CE marking via ETA No. 13/0668 "Kit for Green Roofs", supply as a mechanical protective layer and lay over the entire surface with 10 cm joint overlap.
Product: Zinco Protection Mat TSM 32
Unit: m²
Order Nr.: 2032
These Installation Instructions describe the essential steps for using this product. Please also observe the relevant standards and guidelines, in particular the occupational health and safety regulations.
Installation should not be carried out if there is a risk of storms.
1
Installation:
Protection Mat TSM 32 is laid loosely above the Root Barrier or on the roof already waterproofed with root resistant waterproofing with approximately / approx. 10 cm overlapping. At the edges of roof / perimeter and rising structural elements, it is laid at least up to the upper edge of the covering.
To protect against UV radiation and blowing away, the protective mat must be covered immediately after installation. Short-term protection against wind can also be provided by moistening the mats.
2
Cutting:
We recommend cutting the protective mat with sturdy universal scissors. When cutting, make sure that the waterproofing of the roof is not damaged under any circumstances! If damage does occur, it must be reported and repaired immediately.
The protective mat must be cut in a circle over roof outlets, approximately / approx. 1 cm larger than the roof outlet all round (cross cutting is not sufficient!).
This product is also available in other dimensions / measurements / specifications
Inexpensive synthetic fiber mat for use as a separating and protective layer under gravel layers and extensive green roofs.
Inexpensive synthetic fiber mat for use as a separating and protective layer under gravel layers and extensive green roofs.